A clamp meter measures current without breaking the circuit. You close the jaw around a conductor and read the amps. For electricians, HVAC technicians and plant maintenance teams it is the everyday instrument for checking loads, finding imbalances and proving a circuit is carrying what it should. This guide covers the specifications that separate a meter suited to industrial work from one that is not.
AC only or AC/DC
The sensing method determines what the meter can measure.
- Current transformer jaws measure AC only. They are simple, robust and accurate at mains frequency.
- Hall effect jaws measure both AC and DC. You need these for battery systems, solar installations, DC drives, vehicles and telecom power.
- Flexible (Rogowski) coils measure AC on large or awkward conductors such as busbars and bundled cables, often up to several thousand amps.
If any of your work involves DC, buy an AC/DC meter. DC clamps need zeroing before each measurement to remove the offset from residual magnetism.
True RMS
Variable speed drives, LED lighting and switch-mode power supplies draw current that is not a clean sine wave. An average-responding meter can under-read these loads substantially. A true RMS meter calculates the actual heating value of the waveform and reads correctly. For industrial and commercial work, treat true RMS as essential.
Safety category and voltage rating
Measurement categories describe where in an installation an instrument may safely be used, based on the transient energy available there.
| Category | Typical location |
|---|---|
| CAT II | Plug-connected equipment and socket circuits |
| CAT III | Distribution boards, fixed installation wiring, motors |
| CAT IV | Supply origin, service entrance, utility connections |
Choose a meter rated for the highest category and voltage you will meet, for example CAT III 1000 V or CAT IV 600 V, and check that the test leads carry the same rating. Independent certification marks are a better assurance than a printed rating alone.
Current range and resolution
Match the range to your loads. A 400 A or 600 A meter covers most commercial work, while 1000 A and above suits industrial feeders. At the other end, check the resolution on the lowest range. If you measure small control currents or standby loads, a meter that resolves to 0.01 A is far more useful than one that resolves to 0.1 A.
Jaw size and shape
The jaw has to fit around the conductor and into the space around it. Large jaws take big cables. Slim, tapered jaws reach into crowded panels. For very large conductors, a flexible coil is the practical answer.
Functions worth having
- Inrush current: captures the starting surge of motors and transformers, which helps explain nuisance tripping.
- Low-pass filter: gives stable readings on the output of variable speed drives.
- Voltage, resistance and continuity: lets one instrument handle most checks.
- Capacitance and temperature: useful for HVAC work on capacitors and refrigeration lines.
- Min/max and hold: for readings in places where you cannot see the display.
- Non-contact voltage detection: a quick first check, not a substitute for proving dead.
Leakage clamp meters are a different tool
Finding earth leakage means measuring milliamps, which a standard clamp meter cannot resolve. Leakage clamps have shielded, high-sensitivity jaws for that purpose. If you trace RCD or GFCI tripping, you need one in addition to a general clamp meter.
Browse our instrument collections for professional test equipment.
Frequently asked questions
Can a clamp meter measure DC current?
Only if it uses a Hall effect sensor and is sold as an AC/DC clamp meter. Current transformer models measure AC only.
Do I need true RMS?
Yes for almost any modern installation. Electronic loads distort the waveform, and average-responding meters read them incorrectly.
What CAT rating do I need?
CAT III for work on distribution boards and fixed wiring, CAT IV for work at the supply origin. Pick the voltage rating to match your system.
Why does my clamp meter read zero on a cable?
You have probably clamped a cable containing both live and neutral. Their currents cancel. Clamp a single conductor.