A bench DC power supply provides a stable, adjustable voltage and current for powering circuits under development, test or repair. It is one of the first instruments on any electronics bench, and the choice affects what you can test and how clean your measurements are. This guide explains the specifications for engineers, test technicians and lab managers.
Linear or switching
| Linear | Switching | |
|---|---|---|
| Output noise | Very low | Higher, with high-frequency switching content |
| Efficiency | Low. Excess power becomes heat | High |
| Size and weight | Large and heavy for the power | Compact and light |
| Best for | Analogue, RF and sensitive measurement work | Higher power, general test and production |
For low-noise analogue and RF work, linear is the safer choice. For high power in limited space, switching supplies are the practical one, and good designs keep noise acceptably low for most digital and power electronics work.
Output ratings
Voltage, current and power
List the maximum voltage and current your loads need, and add margin. A conventional supply delivers its full current only up to its rated voltage. An autoranging supply trades voltage for current along a constant-power curve, so one unit covers both high-voltage, low-current and low-voltage, high-current loads.
Number of channels
Circuits with several rails need multiple outputs. Triple-output supplies are common, with two adjustable channels and one fixed or low-voltage channel. Check whether the channels are isolated from each other, and whether they can be connected in series or parallel with tracking.
Performance specifications
- Ripple and noise. The residual AC on the output, quoted in millivolts RMS and peak to peak. Lower is better for sensitive circuits.
- Load regulation. How much the output changes when the load current changes.
- Line regulation. How much the output changes when the mains voltage changes.
- Programming and readback accuracy. How closely the output matches the setting, and how accurately the supply measures its own output.
- Resolution. The smallest step in which voltage and current can be set.
- Transient response. How quickly the output recovers after a sudden load change. This matters when powering digital loads that switch current rapidly.
Constant voltage and constant current
Every bench supply operates in one of two modes. In constant voltage mode it holds the set voltage and supplies whatever current the load draws, up to the current limit. If the load tries to draw more, the supply moves to constant current mode and lets the voltage fall. Setting the current limit before connecting a new circuit is the simplest way to protect it.
Protection
- Over-voltage protection, to shut down the output if it exceeds a set level
- Over-current protection, to switch off instead of limiting
- Over-temperature protection
- An output on/off switch, so settings can be made with the output disconnected
Programmability and remote sense
Programmable supplies accept commands over USB, LAN or GPIB, usually in the standard SCPI command language, and can run stored sequences. They are essential for automated test. Remote sense terminals measure the voltage at the load itself and correct for the drop in the leads, which matters at high currents.
Matching the supply to the work
- General electronics bench: a triple-output linear supply around 30 V and 3 A per channel
- Automated test: a programmable supply with good readback accuracy and LAN or USB control
- Power electronics and battery work: a higher-power switching or autoranging supply with remote sense
- Field service: a compact switching supply
Browse our lab and analytical instruments for professional bench equipment.
Frequently asked questions
Is a linear power supply better than a switching one?
It is quieter, which matters for sensitive analogue work. Switching supplies deliver more power in less space and are better for higher-power loads.
What is the difference between CV and CC?
In constant voltage mode the supply holds voltage and lets current vary. In constant current mode it holds current and lets voltage vary. The supply changes mode automatically at the limits you set.
Can I connect two outputs in series?
Yes, if the outputs are isolated and the manual allows it. Many multi-channel supplies have a series or parallel tracking mode for this.
Do I need remote sense?
It is worth having when you draw several amps through long leads, where the voltage at the load would otherwise be lower than the setting.