A voltage tester answers one question: is this conductor live? Electricians, maintenance technicians and HVAC engineers ask it many times a day, and the answer has to be right every time. This guide explains the main types of voltage tester, what each is good for, and the specifications that matter when you buy one.
The main types
| Type | What it does | Use it for |
|---|---|---|
| Non-contact voltage detector | Senses the electric field around a live AC conductor and lights or beeps | A quick first check. Not for proving a circuit dead |
| Two-pole voltage tester | Two probes make contact and show the voltage on LEDs or a display | Proving dead and confirming supply. The standard tool for safe isolation |
| Digital multimeter | Measures the exact voltage, plus resistance, continuity and more | Diagnosis, where the precise value matters |
| High-voltage detector | Mounted on an insulated stick to check medium and high-voltage lines | Utility and substation work |
Why a non-contact detector is not enough
Non-contact detectors are convenient, and every toolkit should have one. They also fail in ways that matter. They can miss voltage in shielded or deeply buried cables, they do not detect DC, and they can indicate voltage that is only induced from a neighbouring cable. Treat them as a warning device. To confirm a circuit is dead before touching it, use a contact tester.
Specifications that matter
Measurement category and voltage rating
The category rating tells you where in an installation the tester is safe to use. CAT III covers distribution boards and fixed wiring, and CAT IV covers the supply origin. Choose a rating at or above the highest category and voltage you work on, and check that the probes carry the same rating.
Voltage range, AC and DC
Check that the range covers your systems. If you work on solar, batteries, vehicles or control circuits, you need a tester that reads DC and shows polarity.
Low impedance
A high-impedance tester can show a voltage on a disconnected conductor because of capacitive coupling from adjacent live cables. This is often called ghost voltage. A low-impedance tester, or one with a switchable load, pulls that stray voltage down so you see only real supply.
Indication
LED ladders are fast to read and robust. A digital display gives the value. Many testers add a vibration or audible alert, which helps in bright or noisy locations.
Useful extras
- Continuity testing
- Phase rotation indication on three-phase systems
- Single-pole phase detection
- RCD or GFCI trip test function
- A built-in torch and a display backlight
- Ingress protection rating for outdoor and site work
Prove, test, prove
However good the tester is, verify it works every time you rely on it:
- Check the tester on a known live source or a proving unit.
- Test the circuit you are isolating, between all conductors and to earth.
- Check the tester again on the known source.
If the tester fails the final check, the reading in between cannot be trusted.
Browse our instrument collections for professional test equipment.
Frequently asked questions
Can I use a multimeter to prove a circuit dead?
Many site rules prefer a dedicated two-pole tester. It has no range switch to set wrongly and no fuse to blow silently.
Why does my tester show voltage on a disconnected wire?
It is probably induced voltage from parallel live cables. A low-impedance tester will show whether real supply is present.
Do non-contact testers work on DC?
No. They sense the alternating electric field of AC. Use a contact tester for DC.
What CAT rating should I buy?
CAT III 1000 V or CAT IV 600 V covers most commercial and industrial low-voltage work.